INSTRUMENT PANEL DELAMINATION RH & LH DASH DISTORTION OUTLET

MODELS: 1979-1990 G1, G2 AND G3 VANS

Some of the above subject vehicles may over time experience a delamination condition on instrument panels around the defroster outlet area because of a lack of adhesive or poor bonding. Delamination can distort the instrument panel in the areas of the RH and/or LH defroster outlets.

To correct, defroster bezels have been released shielding (covering) the affected defroster outlet area (RH and LH) on the instrument panel.

If the delamination condition does NOT exceed 1/2" in the corners of the defroster outlet area, a defroster outlet bezel can be used. If the delamina- tion condition is greater than that described, it is necessary to replace the instrument panel.

INSTALLATION INSTRUCTIONS: (Refer to Figure 1)

1. Place correct bezel over affected instrument panel defroster outlet area.

2. Using attaching clips, hold bezel in correct position and snap clips over the bezel and defroster outlet as shown in illustration. Four clips can be used on the LH bezel (two additional clips are optional). Two clips are used on the RH bezel.

PARTS INFORMATION

QTY. P/N DESCRIPTION COLOR ----- ---- ----------- ----- 1 15658020 Defroster Bezel-RH Med. Dk. Blue 1 15658011 Defroster Bezel-LH Med. Dk. Blue 6-8 15658037 Clips (LH and RH Bezels)

IMPORTANT: Part numbers have been released for the most frequently used color. If another color is required, the part(s) can be painted to match.

Parts are expected to be available on February 26, 1990. Until then normal part orders will not be accepted by GMSPO. Only verifiable emergency VIP orders will be accepted. SPO will make every effort to obtain parts. All parts will be placed on 400 control to waive VIP surcharges. However, the part will be shipped premium transportation at dealers expense. All other order types will be cancelled as incorrectly ordered while the 400 control is in place.

For vehicles repaired under warranty use:

*Labor Operation: T8085

Labor Time: 0.2 Hrs. (Add 0.1 Hr. to paint to match)

*Labor Operation is coded to base vehicle coverage in the warranty system.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.