Front Side Door Emblem/Nameplate Replacement W/O SS

Tools Required

J 25070 Heat Gun

Important: Use the tape for protection and alignment marks for alignment of the new emblem.

1. Apply tape to the area around the door emblem.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.

Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.



5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
6. Clean the door surface using varnish makers and painters (VMP) naptha.

1. If the location of the emblem/nameplate has not been marked apply tape.
2. Warm the door surface with a heat gun J 25070 152 mm (6 in) from the surface to a minimum of 21°C (70°F).

Important: Do not touch the adhesive backing of the emblem/nameplate.

3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the door emblem.

Front Side Door Emblem/Nameplate Replacement SS

Tools Required

J 25070 Heat Gun

Important: Use the tape for protection and alignment marks for alignment of the new emblem/nameplate.

1. Apply tape to the area around the door emblem/nameplate.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.

Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.



5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
6. Clean the door surface using varnish makers and painters (VMP) naptha.

1. If the location of the emblem/nameplate has not been marked apply tape.
2. Use the following dimensions in order to mark the proper position of the emblem/nameplate on the door:

•	105 mm (4.1 in) (A) from the vertical edge

•	22 mm (0.9 in) (B) from the horizontal edge

3. Warm the door surface with a heat gun J 25070 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
4. Apply tape over the outer surface of the emblem/nameplate to ensure alignment.

Important: Do not touch the adhesive backing of the emblem/nameplate.

5. Remove the backing from the front end of the emblem/nameplate.
6. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
7. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
8. Inspect the emblem/nameplate for bonding.
9. Remove the tape from the emblem/nameplate and the area around the door emblem/nameplate.