- Remove the third accumulator retainer and ball assembly, using a 44.8 mm (1.763 in) #4 screw extractor.
- Scribe a mark at 44.8 mm (1.763 in) (a) on a 9.5 mm (0.375 in) (b) diameter metal rod. The scribe mark is used to gage the proper
depth of the third accumulator retainer and ball assembly.
- Perform the following functions:
| 3.1. | Line up the oil feed slots in the third accumulator retainer and ball assembly (40) with the servo bore. |
| 3.2. | Using the 9.5 mm (0.375 in) diameter metal rod, install the third accumulator retainer and ball assembly. |
- Ensure that the third accumulator retainer and ball assembly and the scribe mark on the rod are flush with the case surface.
- Check the third accumulator retainer and ball assembly (40) for alignment. The slot in the retainer must be completely open in the servo bore.
