1. Loosen the sight shield bolt.
2. Remove the sight shield.
3. Remove the sight shield retainer bolts.
4. Remove the sight shield retainer.



5. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (1).



6. Remove the MAP sensor (1).

Important: Lightly coat the MAP sensor seal with clean engine oil prior to installing.

1. Install the MAP sensor (1).



2. Connect the MAP sensor electrical connector (1).



3. Install the sight shield retainer.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the sight shield retainer bolts.

Tighten
Tighten the bolts to 5 N·m (44 lb in).

5. Install the sight shield.
6. Tighten the sight shield bolt.

Tighten
Tighten the bolt to 10 N·m (89 lb in).