Important: This table assumes that all mechanical linkage and drivers are free from obstruction and not binding.

1. Remove the inoperative power seat switch from the side of seat.
2. Connect a fuse jumper between the respective tilt switch terminals and ground.
3. Connect a fused jumper between CKT 1440 (ORN) cavity H and respective tilt switch terminals.
4. Observe motor operation.
5. Reverse jumper position on switch terminals.
6. Observe motor operation.

Does the tilt motor operate in both directions?

--

Go to Step 3

Go to Step 2

Replace the tilt motor and wiring harness.

Is the repair complete?

--

Go to Power Seats System Check

--

Replace the tilt switch assembly. Refer to Power Seat Switch Replacement .

Is the repair complete?

--

Go to Power Seats System Check

--