Was the instrument panel cluster (IPC) system check performed?

--

Go to Step 2

Go to Instrument Cluster System Check .

1. Turn the ignition switch to the OFF position.
2. Disconnect the low washer switch connector.
3. Turn the ignition switch to the RUN position.
4. With a DMM measure the voltage between the BLK WHT (174) wire cavity A and ground.

Does the DMM display battery voltage?

9-16 volts

Go to Step 3

Go to Step 4

With a DMM, measure voltage between the BLK/WHT (174) wire cavity A and BLK (150) wire cavity B.

Does the DMM display battery voltage?

9-16 volts

Go to Step 6

Go to Step 7

Backprobe the cluster connector with a DMM and measure voltage between the BLK/WHT (174) wire cavity B12 and ground.

Does the DMM display battery voltage?

9-16 volts

Go to Step 5

Go to Step 8

Locate and repair the open BLK/WHT (174) wire between the cluster and low washer switch.

Is the repair complete?

--

Go to Instrument Cluster System Check

--

Replace the low washer switch.

Is the repair complete?

--

Go to Instrument Cluster System Check

--

Locate and repair the open BLK (150) wire between the low washer switch and G100.

Is the repair complete?

--

Go to Instrument Cluster System Check

--

Replace the instrument cluster. Refer to Instrument Cluster Replacement .

Is the repair complete?

--

Go to Instrument Cluster System Check

--