The jacking equipment needed to remove the spare tire is stored under the rear seat. To release the jack from its holder, turn the knob on the jack counterclockwise to lower the jack head. See Rear Seat Operationfor more information.

The tools you will be using include:

1. Wheel Wrench

2. Wheel Blocks

3. Extension(s) (Socket End)

4. Handle (Jack End)

5. Jack

To remove the underbody-mounted spare from your vehicle:

Notice: If you remove or restow a tire from/to the storage position under the vehicle while it is supported by a jack, you could damage the tire and/or your vehicle. Always remove or restow a tire when the vehicle is on the ground.

1. Wheel Wrench

2. Hoist Shaft

3. Extension

4. Retainer

5. Spare or Flat Tire (Valve Stem Pointed Up)

1. Open the liftgate. See Liftgate/Liftglass for more information.
2. Attach the wheel wrench (A) to the extension (C).




Insert the socket end of the extension (C) on a 45 degree angle downward into the hoist drive shaft hole.

3. It is exposed when the rear gate is open and is just above the rear bumper. Be sure the socket end of the extension (C) connects to the hoist shaft.



4. Turn the wheel wrench counterclockwise to lower the spare tire. Keep turning the wheel wrench until the spare tire can be pulled out from under the vehicle.

If the spare tire does not lower to the ground, the secondary latch is engaged causing the tire not to lower. See Secondary Latch System for more information.




5. Tilt the retainer at the end of the cable when the tire has been completely lowered, and pull it through the wheel opening.
6. Pull the tire out from under the vehicle.

Notice: If you drive away before the spare tire or secondary latch system cable has been reinstalled, you could damage your vehicle. Always reinstall this cable before driving your vehicle.

7. Put the spare tire near the flat tire.