GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2003 🢒 Envoy - 4WD 🢒 Body and Accessories 🢒 Seats 🢒 Front Seat Replacement - Bucket

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

  1. Disable SIR. Refer to SIR Disabling and Enabling and to SIR Disabling and Enabling in SIR.

    2. Important: Before removing the seat, ensure that the following conditions are met:

       • For power seats, verify that the seat bottom is fully down.
       • The seat back is in the full upright position.
       • The upper and lower seat rails are flush at rear.

  2. Remove the seat mounting fastener covers.

    3. Object Number: 722607 Size: SH
  3. Remove the 3 front seat mounting nuts.
  4. Remove the front seat mounting bolt.
  5. Disconnect the electrical harness. Unclip the harness from the seat bracket.
  6. Remove the seat from the vehicle.
  7. Place the seat on a clean, prepared surface.

Installation Procedure

    Object Number: 722607 Size: SH
  1. Install the seat to the vehicle.

    2. Important: Do not move or adjust the seat adjuster release handle or the seat back until all 4 fastener attachments have been made. Do not tighten the front seat mounting bolt until the remaining 3 mounting nuts have been tightened.

  2. Install the front seat mounting bolt. Do not tighten.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the three front seat mounting nuts on the floor studs.

    4. Tighten
    Tighten the front seat mounting nuts to 45 N·m (33 lb ft).

    Tighten
    Tighten the front seat mounting bolt to 45 N·m (33 lb ft).

  4. Connect the electrical harness. Clip the harness to the seat bracket.
  5. Enable SIR. Refer to SIR Disabling and Enabling and to SIR Disabling and Enabling in SIR.
  6. Install the seat mounting fastener covers.