For 1990-2009 cars only
Removal Procedure
- Close the window to the full up position.
- Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Remove the rear half of the water deflector from the door.
- Release the upper lock rod retainer (1) from the rod.
- Remove the lock rod from the handle assembly.
- Release the lock cylinder rod retainer (2) from the lock rod, if equipped.
- Remove the lock cylinder rod from the handle assembly, if equipped.
- Remove the 2 door handle retaining nuts.
- Remove the handle assembly from the door.
- Remove the lock cylinder from the handle, if equipped. Refer to Door Lock Cylinder Replacement .
Installation Procedure
- Install the lock cylinder to the handle, if equipped. Refer to Door Lock Cylinder Replacement .
- Install the handle assembly to the door.
- Install the upper lock rod to the handle assembly.
- Install the lock rod retainer (1).
- Install the lock cylinder rod to the handle assembly, if equipped.
- Install the cylinder lock rod retainer (2), if equipped.
- Install the 2 door handle retaining nuts.
- Attach the rear half of the water deflector to the door.
- Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nuts to 10 N·m (88 lb in).
