GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 1999 🢒 Envoy - 4WD 🢒 Steering 🢒 Steering Wheel and Column - Tilt 🢒 Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle

Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle Column Shift


    Object Number: 293254 Size: SH
  1. Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
  2. Place the ignition switch in the OFF position. Remove the key.

    3. Object Number: 293252 Size: SH
  3. Install the wave washer (1) onto the steering shaft assembly (2).

    4. Object Number: 415291 Size: SH

    Important: A new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.

  4. If reusing the original inflatable restraint steering wheel module coil, refer to Inflatable Restraint Coil Centering - Off Vehicle .
  5. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
  6. Slide the new inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
  7. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
  8. Remove the centering tab and disconnect from the new inflatable restraint steering wheel module coil (4).

    9. Object Number: 415293 Size: SH
  9. Reconnect the inflatable restraint steering wheel module coil connector to the turn signal switch assembly connector.
  10. Attach a new wire harness assembly (1) to the wire harness strap (2) and the steering column.
  11. Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .

Inflatable Restraint Steering Wheel Module Coil Assemble - Off Vehicle Floor Shift


    Object Number: 293254 Size: SH
  1. Align the block tooth on the steering shaft assembly (1) to the 12 o'clock position.
  2. Place the ignition switch in the OFF position. Remove the key.

    3. Object Number: 293252 Size: SH
  3. Install the wave washer (1) onto the steering shaft assembly (2).

    4. Object Number: 322951 Size: SH

    Important: A new inflatable restraint steering wheel module coil will be pre-centered. Do not remove the centering tab from the new inflatable restraint steering wheel module coil until the installation is complete.

    If reusing the original inflatable restraint steering wheel module coil, refer to Inflatable Restraint Coil Centering - Off Vehicle .

  4. Align the inflatable restraint steering wheel module coil (4) with the horn tower on the turn signal cancel cam assembly (1).
  5. Slide the new inflatable restraint steering wheel module coil (4) onto the steering shaft assembly (2).
  6. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
  7. Remove the centering tab and disconnect from the new inflatable restraint steering wheel module coil (4).

    8. Object Number: 415293 Size: SH
  8. Reconnect the inflatable restraint steering wheel module coil connector to the turn signal switch assembly connector.
  9. Attach the wire harness assembly (1) to the steering column wire harness strap (2).
  10. Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .