GM Service Manual Online
For 1990-2009 cars only

With cruise control, a speed of about 25 mph (40 km/h) or more can be maintained without keeping your foot on the accelerator. Cruise control does not work at speeds below about 25 mph (40 km/h).

If you apply the brakes, the cruise control shuts off.

Caution: Cruise control can be dangerous where you cannot drive safely at a steady speed. So, do not use the cruise control on winding roads or in heavy traffic.

Cruise control can be dangerous on slippery roads. On such roads, fast changes in tire traction can cause excessive wheel slip, and you could lose control. Do not use cruise control on slippery roads.


Object Number: 807914  Size: A2

The cruise controls are located on the end of the turn signal/multifunction lever.

(Off): Turns the cruise control system off and cancels the set speed memory.

(On): Turns the cruise control system on.

(Resume/Accelerate): Resume a set speed or to accelerate.

(Set): Press this button, located at the end of the lever, to set a speed.

Caution: If you leave your cruise control on when you are not using cruise, you might hit a button and go into cruise when you do not want to. You could be startled and even lose control. Keep the cruise control switch off until you want to use cruise control.

Setting Cruise Control

  1. Move the cruise control switch to .
  2. Get up to the desired speed.
  3. Press at the end of the lever and release it.
  4. Take your foot off the accelerator pedal. The accelerator pedal will not go down.

Object Number: 806861  Size: A1

Some vehicles have a cruise light on the instrument panel cluster that will come on when the cruise control is engaged.

Resuming a Set Speed

If the cruise control is set at a desired speed and then the brake is applied, this shuts off the cruise control. But it does not need to be reset.

Once the vehicle is going about 25 mph (40 km/h) or more, move the cruise control switch briefly from to .

The vehicle returns to the previously chosen speed and stays there.

If the switch is held on resume/accelerate, the vehicle keeps going faster until the switch is released or the brakes are applied. So unless you want the vehicle to go faster, do not hold the switch at resume/accelerate.

Increasing Speed While Using Cruise Control

There are two ways to go to a higher speed:

    • Use the accelerator pedal to get to the desired speed. Press at the end of the lever, then release the button and the accelerator pedal. The vehicle will now cruise at the higher speed.
    • Move the cruise switch from to . Hold it there until the vehicle reaches the desired speed and then release the switch. To increase the vehicle speed in small amounts, move the switch briefly to resume/accelerate. Each time this is done, the vehicle goes about 1 mph (1.6 km/h) faster.

Reducing Speed While Using Cruise Control

Press at the end of the lever until the desired speed is reached, then release it. Each time this is done, the vehicle goes about 1 mph (1.6 km/h) slower.

Passing Another Vehicle While Using Cruise Control

Use the accelerator pedal to increase the vehicle speed. When you take your foot off the pedal, the vehicle will slow down to the cruise control speed set earlier.

Using Cruise Control on Hills

How well the cruise control works on hills depends upon the vehicle speed, load and the steepness of the hills. When going up steep hills, you may want to step on the accelerator pedal to maintain your speed. When going downhill, you may have to brake or shift to a lower gear to keep your speed down. When the brakes are applied the cruise control will disengage.

Ending Cruise Control

There are three ways to turn off the cruise control:

    • Step lightly on the brake pedal.
    • Move the cruise switch to , or
    • Shift the transmission to NEUTRAL (N).

Erasing Speed Memory

The cruise control set speed memory is erased when the cruise control or the ignition is turned off.