GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2009 🢒 Canyon Pickup - 4WD 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Radio Replacement

Removal Procedure
  1. Remove the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.

    2. Object Number: 1251725 Size: SH
  2. Remove the 3 screws that retain the radio to the instrument panel (I/P).
  3. Partially remove the radio disengaging the radio rear alignment locator to gain access to the electrical connectors.

    4. Object Number: 1328319 Size: SH
  4. Disconnect the radio antenna cable.
  5. Disconnect the electrical connectors to the radio.
  6. Remove the radio from the vehicle.

Installation Procedure

    Object Number: 1328319 Size: SH
  1. Position the radio to the I/P.
  2. Connect the electrical connectors to the radio.
  3. Connect the radio antenna cable to the radio.
  4. Position the radio rear alignment locator into the I/P substrate installing the radio to the I/P.

    5. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1251725 Size: SH
  5. Install the 3 screws that retain the radio to the I/P.

    6. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  6. Install the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement.
  7. Program the replacement radio. Refer to Control Module References.