For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1001 00: Option Configuration ErrorDTC B1001 45: Option Configuration Error Variant Not Programmed
DTC B1001 46: Option Configuration Error
DTC B1001 4B: Option Configuration Error Calibration Not Learned
Circuit/System Description
Some control modules must be configured with serial numbers, vehicle options, or other information. If a control module was not properly configured after installation, that module may set DTC B1001.
Conditions for Running the DTC
Battery voltage is between 9-16 volts and data link communications operate normally.
Conditions for Setting the DTC
The control module is not configured properly.
Conditions for Clearing the DTC
| • | A current DTC clears when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
Circuit/System Verification
- Program or configure the module or related module that set DTC B1001. The module should successfully configure.
- With a scan tool, clear the DTC.
- Ignition OFF, remove the scan tool, open and close the drivers door.
- Wait 60 seconds, then recheck for DTCs. DTC B1001 should not set.
| ⇒ | If the module will not configure, replace the module that set the DTC. |
| ⇒ | If DTC B1001 sets, replace the module. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for control module replacement, setup, and programming
