GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2008 🢒 Canyon Pickup - 2WD 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Digital Radio Receiver Replacement

Removal Procedure

    Important: Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock®, and "XM Theftlock®" will display.

  1. Remove the instrument panel (I/P) compartment door. Refer to Instrument Panel Compartment Door Replacement .

    2. Object Number: 1364141 Size: SH
  2. Unfold the service panel located above the I/P compartment door.

    3. Object Number: 1251728 Size: SH
  3. Remove the I/P access cover.

    4. Object Number: 1364138 Size: SH
  4. Remove the screws retaining the digital radio receiver to the I/P structure.

    5. Object Number: 1364140 Size: SH
  5. Lower the receiver from the I/P.

    6. Important: Do not attempt to pry or slide the electrical connector release lever (1).


    Object Number: 1408369 Size: SH
  6. Disconnect the electrical connector by pushing on the release lever (1).

    7. Object Number: 1408373 Size: SH
  7. Remove the connector position assurance (CPA) (2) from the electrical connector.
  8. Remove the connector from the receiver.
  9. Remove the receiver from the vehicle.

    10. Object Number: 1364133 Size: SH
  10. If replacing the receiver, remove the nuts retaining the receiver to the mounting bracket.
  11. Remove the receiver from the mounting bracket.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1364133 Size: SH
  1. If replacing the receiver, install the receiver to the mounting bracket and install the retaining nuts.

    2. Tighten
    Tighten the nuts to 3 N·m (26 lb in).


    Object Number: 1408373 Size: SH
  2. Position the receiver to the I/P.
  3. Connect the receiver electrical connectors.
  4. Install the CPA (2) to the electrical connector.

    5. Object Number: 1364140 Size: SH
  5. Install the receiver to the I/P.

    6. Object Number: 1364138 Size: SH
  6. Install the screws retaining the digital radio receiver to the I/P structure.

    7. Tighten
    Tighten the screws to 3 N·m (27 lb in).


    Object Number: 1364141 Size: SH
  7. Close the service panel located above the I/P compartment door.
  8. Install the I/P compartment door. Refer to Instrument Panel Compartment Door Replacement .
  9. Install the I/P access cover.
  10. Perform the setup procedure for the digital radio receiver. Refer to Control Module References .