GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1749357  Size: SH
  1. Open the hood.
  2. From under the hood, disconnect the secondary air injection (AIR) pump inlet hose quick connect fitting (1) from the pump. Refer to Plastic Collar Quick Connect Fitting Service.
  3. Disconnect the AIR pump outlet hose quick connect fitting (2) from the pump. Refer to Plastic Collar Quick Connect Fitting Service.
  4. Remove the engine shield. Refer to Engine Protection Shield Replacement .

  5. Object Number: 1749359  Size: SH
  6. Disconnect the engine wiring harness electrical connector from the AIR pump wiring harness electrical connector.

  7. Object Number: 1749365  Size: SH
  8. Squeeze the AIR pump wiring harness electrical connector clip (1) together and push up in order to separate the clip/connector from the bracket.
  9. Open the AIR pump wiring harness clip (2) and remove the harness from the clip.

  10. Object Number: 1749367  Size: SH
  11. Remove the AIR pump nuts (1).
  12. Lower the vehicle.
  13. Reposition the AIR pump inlet and outlet hoses as necessary in order to remove the pump.
  14. Remove the AIR pump.

Installation Procedure


    Object Number: 1749367  Size: SH
  1. Install the AIR pump.
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
  3. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the AIR pump nuts (1).
  5. Tighten
    Tighten the nuts to 9 N·m (80 lb in).


    Object Number: 1749365  Size: SH
  6. Install the AIR pump wiring harness electrical connector clip (1) to the bracket.
  7. Install the AIR pump wiring harness to the clip (2) and close the clip.

  8. Object Number: 1749359  Size: SH
  9. Connect the engine wiring harness electrical connector to the AIR pump wiring harness electrical connector.
  10. Install the engine shield. Refer to Engine Protection Shield Replacement.

  11. Object Number: 1749357  Size: SH
  12. Position the AIR pump inlet and outlet hoses as necessary.
  13. Connect the AIR pump outlet hose quick connect fitting (2) to the pump. Refer to Plastic Collar Quick Connect Fitting Service.
  14. Connect the AIR pump inlet hose quick connect fitting (1) to the pump. Refer to Plastic Collar Quick Connect Fitting Service.
  15. Close the hood.