For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1001: Option Configuration ErrorCircuit/System Description
The body control module (BCM) stores the last 4 digits of the sensing and diagnostic module (SDM) part number, also called restraints ID. After the BCM is reprogrammed the restraints ID is set to zero. A restraints ID relearn must be performed for the BCM to learn the restraints ID.
Conditions for Running the DTC
Battery voltage is between 9-16 volts and data link communications operate normally.
Conditions for Setting the DTC
The restraints ID stored in the BCM memory is zero.
Conditions for Clearing the DTC
| • | A current DTC clears when the condition is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
Circuit/System Verification
Program the body control module (BCM). Refer to Body Control Module Programming and Setup .
| ⇒ | If the DTC remains current, replace the BCM. Refer to Repair Instructions. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for BCM replacement, setup, and programming
