GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1352026  Size: SH
  1. Remove the air cleaner resonator and outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .
  2. Disconnect the evaporative emission (EVAP) canister purge pipe (1) from the throttle control module (2). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Disconnect the engine wiring harness electrical connector from the throttle body control module.

  4. Object Number: 1769041  Size: SH
  5. Remove the throttle control module bolts.
  6. Remove the throttle body control module and the seal from the intake manifold.
  7. Clean the gasket surface.

Installation Procedure


    Object Number: 1769041  Size: SH
  1. Install a NEW seal into the intake manifold groove.
  2. Position the throttle body control module to the intake manifold.
  3. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the throttle body control module bolts.
  5. Tighten
    Tighten the bolts to 10 N·m (89 lb in).


    Object Number: 1352026  Size: SH
  6. Connect the engine wiring harness electrical connector to the throttle body control module.
  7. Connect the EVAP canister purge pipe (1) to the throttle body control module. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Install the air cleaner resonator and outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .