Step | Action | Yes | No | ||||
|---|---|---|---|---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views | |||||||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |||||
2 | Verify that the backup lamps are inoperative. Do the backup lamps operate normally? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 | ||||
3 | Is only one backup lamp inoperative? | Go to Step 5 | Go to Step 4 | ||||
4 | Use the scan tool to check if there are any codes set in the current or history Powertrain DTC Information. Are any codes present? | Go to Step 6 | |||||
5 | Test the backup lamp supply voltage and ground circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs . Did you find and correct a condition? | Go to Step 10 | Go to Step 8 | ||||
6 | Test the following circuits for an open, high resistance, or a short to ground. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct a condition? | Go to Step 10 | Go to Step 7 | ||||
7 | Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 10 | Go to Step 9 | ||||
8 | Replace the affected backup lamp bulb. Refer to Tail Lamp Replacement . Did you complete the replacement? | Go to Step 10 | -- | ||||
9 | Replace the BCM. Refer to Control Module References for BCM replacement, setup, and programming. Did you complete the replacement? | Go to Step 10 | -- | ||||
10 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 | ||||
