For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1019 3A: SDM System Configuration Error Incorrect Component InstalledCircuit/System Description
The inflatable restraint and sensing diagnostic (SDM) is programmed to monitor the number of impact sensors and deployment loops connected. When the ignition is turned ON, the SDM evaluates the number of deployment loops and impact sensors and if a mismatch is detected between the number that the SDM expects and the actual number present, DTC B1019 will set.
Conditions for Running the DTC
Ignition voltage is between 9-16 V.
Conditions for Setting the DTC
| • | The incorrect SDM is installed on the vehicle. |
| • | The incorrect software or calibrations have been flashed into the SDM. |
Action Taken When the DTC Sets
The SDM requests the instrument panel cluster to illuminate the AIR BAG warning indicator.
Conditions for Clearing the DTC
| • | The condition for setting the DTC is no longer present. |
| • | A history DTC will clear once 100 malfunction-free ignition cycles have occurred. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Verify that DTC B1019 is not set.
| ⇒ | If the DTC is set, program the K36 SDM. If the DTC resets, replace the K36 SDM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for SDM replacement, setup, and programming |
