Diagnostic Instructions
DTC Descriptor
DTC P0634: Transmission Control Module (TCM) Overtemperature
Circuit/System Description
The transmission control module (TCM) temperature sensor is located inside of the control solenoid (w/body and TCM) valve assembly. The control solenoid (w/body and TCM) valve assembly has no serviceable parts. This fault indicates the TCM is in
an overtemperature condition and the TCM has shut down to protect itself from possible heat damage. The TCM will remain off until the over temperature condition no longer exists.
Conditions for Running the DTC
| • | Ignition voltage is between 9.0 volts and 19.0 volts. |
| • | The TCM temperature is between 0°C (32°F) and 240°C (464°F) for 0.25 seconds or greater. |
| • | DTC P0634 has not failed this ignition cycle. |
Conditions for Setting the DTC
Fail Case 1
The TCM has detected an internal overtemperature condition greater than 144°C (291°F) for 5 seconds or greater.
OR
Fail Case 2
Ignition voltage is 18 volts or greater and the TCM temperature is greater than 50°C (122°F) for 2 seconds.
Action Taken When the DTC Sets
| • | DTC P0634 is a Type A DTC. |
| • | The TCM shifts to a default gear, shuts down, and turns OFF. |
Conditions for Clearing the DTC
DTC P0634 is a Type A DTC.
Reference Information
Description and Operation
Electronic Component Description for control solenoid (w/body and TCM) valve assembly information.
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Ignition ON, review the Failure Records when the DTC set. Verify the scan tool ECT Sensor parameter was less than 125°C (257°F).
| ⇒ | If greater than the specified range, refer to 37218. |
- Perform the
Transmission Fluid Check to verify correct fluid level and condition. The transmission fluid level should be within the crosshatch band and the transmission fluid should be red or dark brown.
- Perform the
Transmission Fluid Cooler Flushing and Flow Test to verify proper transmission oil cooler flow.
- Operate the vehicle within the conditions for running and setting the DTC. Verify the scan tool TCM Temperature parameter is less than 146°C (295°F).
| ⇒ | If greater than the specified range, inspect the transmission cooling system for the items list below and repair as necessary. If all the items test normal, replace the control solenoid (w/body and TCM) valve assembly: |
| • | Obstructions to the airflow of the radiator or transmission due to debris |
| • | Kinked of damaged transmission fluid lines |
| • | Damage to the transmission cooler |
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Repair Instructions
Perform the
Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Refer to
Control Module References for control solenoid (w/body and TCM) valve assembly replacement, setup, and programming. |
