GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2002 🢒 Venture - 4WD 🢒 Engine 🢒 Engine Controls - 3.4L 🢒 Engine Splash Shield Replacement

Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

Removal Procedure
  1. Use J 38778 in order to remove the push-in retainers from the engine compartment side rail.
  2. Use J 38778 in order to remove the push-in retainers from the front fender liner at the engine splash shield.

    3. Object Number: 315248 Size: SH
  3. Remove the front wheel speed jumper harness from the left engine splash shield. Refer to Front Wheel Speed Sensor Replacement in Antilock Brake System.

    4. Object Number: 315247 Size: SH
  4. Remove the front wheel speed jumper harness from the right engine splash shield. Refer to Front Wheel Speed Sensor Replacement in Antilock Brake System.
  5. Remove the engine splash from the vehicle.

Installation Procedure

    Object Number: 315248 Size: SH

    Important: The battery cable and the ABS harness must be installed to the engine splash shield prior to installation of the engine splash shield to the body.

  1. Install the front wheel speed jumper harness to the left engine splash shield. Refer to Front Wheel Speed Sensor Replacement in Antilock Brake System.

    2. Object Number: 315247 Size: SH
  2. Install the front wheel speed jumper harness to the right engine splash shield. Refer to Front Wheel Speed Sensor Replacement in Antilock Brake System.
  3. Align the engine splash shield to the vehicle engine compartment side rail.
  4. Install the push-in retainers to the engine compartment side rail.
  5. Install the push-in retainers to the front fender liner at the engine splash shield.