GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Venture Ext. 🢒 Engine 🢒 Engine Cooling 🢒 Front End Sheet Metal Diagonal Brace Replacement - Left Side

Removal Procedure

    Object Number: 315245 Size: SH
  1. Open and support the hood.
  2. Remove the windshield wiper system module cover. Refer to Wiper Module Cover Replacement in Wipers Washer/Systems.
  3. Remove the coolant recovery reservoir on the left front end sheet metal diagonal brace. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
  4. Remove the cruise control module on the left front end sheet metal diagonal brace. Refer to Cruise Control Module Replacement in Cruise Control.
  5. Remove the bolt from the rear hole in the front end sheet metal diagonal brace at the wheelhouse.
  6. Remove the bolts from the front of the front end sheet metal diagonal brace at the upper tie bar.
  7. Remove the front end sheet metal diagonal brace from the engine compartment.

Installation Procedure

    Object Number: 315245 Size: SH
  1. Install the front end sheet metal diagonal brace to the engine compartment.
  2. Align the rear hole of the front end sheet metal diagonal brace to the hole in the wheelhouse.
  3. Align the holes of the front end sheet metal diagonal brace to the holes in the upper tie bar.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the bolts to the front of the front end sheet metal diagonal brace at the upper tie bar.

    5. Tighten
    Tighten the bolts to 25 N·m (18 lb ft).

  5. Install the bolt to the rear hole in the front end sheet metal diagonal brace at the wheelhouse.

    6. Tighten
    Tighten the bolt to 47 N·m (34 lb ft).

  6. Install the windshield wiper system module cover. Refer to Wiper Module Cover Replacement in Wipers Washer Systems.
  7. Install the coolant recovery reservoir on the left front end sheet metal diagonal brace. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
  8. Install the cruise control module on the left front end sheet metal diagonal brace. Refer to Cruise Control Module Replacement in Cruise Control.
  9. Close the hood.