Removal Procedure
- Remove the sliding door striker screws.
- Remove the sliding door striker and the shim from the C-pillar.
Installation Procedure
- Install the sliding door striker and the shim to the C-pillar.
- Install the sliding door striker screws.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Important:
• The striker is mounted through an oversized hole into a caged
nut. This arrangement allows approximately 4 mm (0.15 in) of
adjustment. • If the striker does not properly engage the door lock, the door
needs to be adjusted within the door frame. Refer to the appropriate procedure: • Use the striker in order to adjust the door for flushness. Do
not use the striker in order to raise or lower the door. • The latch should contact the center of the striker. If the latch
to striker alignment is incorrect, add or remove shims as required in order
to achieve proper alignment.
Tighten
Tighten the sliding door striker screws to 25 N·m (18 lb ft).
