Tools Required

J 34094-A Thermo Element Height Gage

1. Remove the oil pan. Refer to Oil Pan Replacement .



2. Remove the thermo element pins and washers (120 and 123).
3. Remove the thermo element (121) and the thermo element plate  (122).

1. Use the J 34094-A to set the middle thermo pin (123).
2. Install the new thermo element plate (122).
3. Install the pin and washer (120).
4. Use the J 34094-A to set the height of the pin and washer (120) furthest from the accumulator.
5. Use the J 34094-A to set the height of the second pin and washer (120).



6. Carefully install the thermo element (121) between the two pin and washers (120). The V in the thermo element (121) must contact the thermo element plate (122).
7. Install the oil pan. Refer to Oil Pan Replacement .

Important: It is recommended that the transmission adaptive pressure (TAP) information be reset. Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the ECM, PCM or TCM will need to relearn the TAP values. Transmission performance may be affected as new TAP values are learned.

8. Reset the TAP values. Refer to Adapt Function.
9. Refill fluid as necessary. Refer to Approximate Fluid Capacities .