GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Venture 🢒 Transmission/Transaxle 🢒 Automatic Transaxle - 4T65-E 🢒 Flywheel to Torque Converter Bolt Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the torque converter cover. Refer to Torque Converter Cover Replacement .
  3. Remove the starter motor. Refer to Starter Motor Replacement in Engine Electrical.

    4. Object Number: 160984 Size: SH
  4. Remove the flywheel to torque converter bolts.

Installation Procedure

    Object Number: 160984 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the flywheel to torque converter bolts.

    2. Tighten
    Tighten the flywheel to torque converter bolts to 63 N·m (47 lb ft).

  2. Install the starter motor. Refer to Starter Motor Replacement in Engine Electrical.
  3. Install the torque converter cover. Refer to Torque Converter Cover Replacement .
  4. Lower the vehicle.