Removal Procedure
- Remove the plastic plugs from the lower front of the sliding door inner trim panel in order to gain access to the sliding door lower roller bracket to door bolts.
- Remove the close-out panel on the center rear of the sliding door inner trim panel in order to gain access to the sliding door center roller bracket bolts.
- Loosen 1 of the bolts on the sliding door lower roller bracket.
- Adjust the front edge of the sliding door up or down, as needed.
Important: Loosen only 1 bolt at a time on the following brackets:
• The sliding door lower roller bracket • The sliding door center roller bracket
Installation Procedure
- Tighten the bolt that you loosened on the sliding door lower roller bracket.
- Install the close-out panel on the center rear of the sliding door inner trim panel in order to cover the sliding door center roller bracket bolts.
- Install the plastic plugs to the lower front of the sliding door Inner trim panel in order to cover the sliding door lower roller bracket bolts.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the sliding door lower roller bracket bolt to 25 N·m
(18 lb ft).
