For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC 013: Level Control Sensor CircuitCircuit/System Description
The automatic level control sensor monitors the body to suspension height and detects when it is out of range.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
When the automatic level control sensor detects body to suspension height is out of range, 0.5-4.5 volts, for at least 1 second.
Action Taken When the DTC Sets
| • | Leveling functions are disabled. |
| • | The accessory inflator function continues to operate. |
Conditions for Clearing the DTC
The conditions that caused the DTC to set have been removed.
Diagnostic Aids
| • | This DTC is set when ride height is physically being held out of range. |
| • | This DTC can set when the sensor link is damaged or detached. |
Reference Information
Schematic Reference
Automatic Level Control Schematics
Connector End View Reference
Description and Operation
Automatic Level Control Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Verify that the DTC sets within the Conditions for Running and Setting. Inspect the automatic level control sensor link for damage or being disconnected.
- Perform the automatic level control sensor replacement procedure.
- Operate the vehicle within the conditions that the customer experienced and verify the DTC does not reset.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Important: System untested code will continue to flash until self test has been completed after the automatic level control sensor replacement.
| • | Control Module References for automatic level control sensor replacement, setup, and programming |
