For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B1011: System Disabled Information StoredCircuit/System Description
The power sliding door module (PSDM) can detect when the clutch assembly cable is not connected. A disconnected or broken cable, cable bracket or a cable fastener are the only events which can cause the DTC to be set. Except for the serial data communications circuits, no electrical circuits are involved in the setting of this DTC.
Conditions for Running the DTC
A power sliding door close function is attempted.
Conditions for Setting the DTC
The PSDM has detected that the power sliding door motor and clutch assembly cable is no longer connected.
Action Taken When the DTC Sets
All further power operation is inhibited.
Conditions for Clearing the DTC
| • | The DTC will be current for as long as the cable failure is present. |
| • | When the failed cable assembly has been replaced, the DTC will be cleared due to PSDM being unpugged or power disconnected. |
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Power Sliding Door (PSD) Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
| ⇒ | Inspect the cable assembly on the power sliding door. If the cable assembly is broken, replace the cable assembly. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for PSDM replacement, programming, and setup. |
