GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Uplander Ext. 🢒 Body Repair 🢒 Frame and Underbody 🢒 Rear Suspension Support Nut Replacement

Removal Procedure
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the carpet from the trunk area. Refer to Floor Panel Carpet Replacement .
  3. Remove the following components as needed:
    4. • The sealers
    • The sound deadening materials
    • The corrosion materials
  4. Remove the rear suspension support bolt.
  5. Place a center punch through the damaged rear suspension support nut. Strike the center punch using a hammer. The punch will leave a dimple on the floor. Use the dimple in order to locate the area where the frame crossmember nut will be removed.

    6. Important: Do not cut or damage the adjacent panels or the reinforcements.


    Object Number: 478735 Size: SH
  6. Use a cutoff wheel in order to cut an access panel.
  7. Lift the panel upward in order to gain access to the frame crossmember nut retainer.

    8. Important: Reuse the frame crossmember nut retainer if the retainer is not damaged from the stripped out bolt.


    Object Number: 482315 Size: SH
  8. Use an air chisel in order to break away the spot welds (1) on one side of the frame crossmember nut retainer (3).
  9. Lift one side of the frame crossmember nut retainer enough in order to remove the frame crossmember nut.
  10. Remove the rear suspension support nut (2).

Installation Procedure

    Object Number: 482315 Size: SH
  1. Install the rear suspension support nut (2).
  2. Lower the frame crossmember nut retainer into place. Ensure that the following conditions exist:
    3. • The frame crossmember nut is correctly positioned.
    • The frame crossmember nut operates correctly.
  3. Spot weld the frame crossmember nut retainer in the original location.
  4. Clean and prepare the welded surfaces.
  5. Apply corrosion protection. Refer to Anti-Corrosion Treatment and Repair .

    6. Notice: Refer to Fastener Notice in the Preface section.

  6. Install the new rear suspension support bolt to the frame crossmember nut.

    7. Tighten
    Tighten the bolt to 130 N·m (96 lb ft).


    Object Number: 478735 Size: SH
  7. Reposition the panel downward to the original position.
  8. Stitch weld the panel back to the original position using 25 mm (0.98 in) welds along the seam. Leave 25 mm (0.98 in) gaps between the welds. A solid joint with minimal heat distortion will result. Continue to finish the stitch weld procedure.
  9. Use a small grinder in order to remove the excess material from the floor panel until the following conditions exist:
    10. • The floor panel is smooth.
    • The floor panel is free from rough edges.
  10. Clean and prepare the welded surfaces.
  11. Apply anti-corrosion compound GM P/N 12346225 or equivalent. Thoroughly coat the inside of the repair area through the access hole.
  12. Apply Primer and let the primer dry for approximately 30 minutes. Then apply Dominion Sure Seal P/N 110900 Sound Deadener or the equivalent to the repair area.
  13. Install the carpet and the pad over the repair area Refer to Floor Panel Carpet Replacement .
  14. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .