Upper Intake Manifold Sight Shield Replacement 6.0L

1. Loosen intake manifold sight shield wing nut.
2. Gently lift up in order to disengage the sight shield from the ball stud.
3. Remove the sight shield from the sight shield retainer.



4. Remove the sight shield retainer bolts and the retainer, if required.
5. Remove the sight shield ball stud, if required.

Caution: Refer to Fastener Caution in the Preface section.




1. Install the sight shield ball stud, if required.

Tighten
Tighten the stud to 5 N·m (44 lb in).

2. Position the sight shield retainer to the intake manifold and install the bolts, if required.

Tighten
Tighten the bolts to 3 N·m (26 lb in).





Caution: Use the connector test adapter kit J 35616-A for any test that requires probing the following items:

•	The PCM harness connectors

•	The electrical center fuse/relay cavities

•	The component terminals

•	The component harness connector

Using this kit will prevent damage caused by the improper probing of connector terminals.
3. Install the sight shield to the sight shield retainer.
4. Seat the sight shield onto the ball stud and press down over the stud in order to secure the sight shield.
5. Tighten intake manifold sight shield wing nut until snug.