Tools Required

J 44227 Rear Seal Installer

1. Remove the transmission. Refer to Transmission Replacement .
2. Remove the flywheel. Refer to Engine Flywheel Replacement .

Important: Do not damage the crankshaft or seal bore.




3. Pry the crankshaft rear oil seal out of the rear oil seal housing using a suitable tool.

Important: Use the plastic installation sleeve supplied with the new seal when installing a new seal.

1. Use J 44227 to install the crankshaft rear oil seal.
2. Remove the J 44227 .
3. Remove the seal installation sleeve after the seal is installed. Discard the sleeve.
4. Install the flywheel. Refer to Engine Flywheel Replacement .
5. Install the transmission. Refer to Transmission Replacement .