GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 TrailBlazer - 2WD 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 Instrument Panel Cluster Trim Plate Bezel Replacement

Instrument Panel Cluster Trim Plate Bezel Replacement Chevrolet

Removal Procedure
  1. Tilt the steering wheel to the full down position.
  2. Remove the left closeout/insulator panel . Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  3. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .

    4. Object Number: 712814 Size: SH
  4. Remove the screws retaining the bezel to the instrument panel.
  5. Remove the bezel from the instrument panel.
  6. If equipped, remove the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement .
  7. Remove the rear wiper washer switch. Refer to Rear Window Wiper and Washer Switch Replacement .
  8. If equipped, remove the cigar lighter or 12-volt power supply outlets. Refer to 12-Volt Accessory Power Receptacle Replacement .
  9. Remove the bezel from the vehicle.

Installation Procedure

    Object Number: 712814 Size: SH
  1. If equipped, install the cigar lighter or 12-volt power supply outlets. Refer to 12-Volt Accessory Power Receptacle Replacement .
  2. Install the rear wiper washer switch. Refer to Rear Window Wiper and Washer Switch Replacement .
  3. If equipped, install the transfer case shift control switch. Refer to Transfer Case Shift Control Switch Replacement .
  4. Install the bezel to the instrument panel.

    5. Notice: Refer to Fastener Notice in the Preface section.

  5. Install the screws retaining the bezel to the instrument panel.

    6. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  6. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  7. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .

Instrument Panel Cluster Trim Plate Bezel Replacement GMC

Removal Procedure
  1. Tilt the steering wheel to the full down position.
  2. Remove the left closeout/insulator panel . Refer to Instrument Panel Insulator Panel Replacement - Left Side .
  3. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .

    4. Object Number: 740924 Size: SH
  4. Remove the screws that retain the bezel to the instrument panel.
  5. Remove the bezel from the instrument panel.

Installation Procedure

    Object Number: 740924 Size: SH
  1. Install the bezel to the instrument panel.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the screws that retain the bezel to the instrument panel.

    3. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  3. Install the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  4. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .