Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B3265 00: Trunk/Hatch/Liftgate Release Output CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Liftglass Release Switch Signal | 1 | 1 | 1 | -- |
Liftglass Release Control | B3265 00 | B3265 00 | B3265 00 | -- |
Liftglass Release Actuator Control 2 | 1 | 1 | 1 | -- |
Liftglass Release Switch Ground | -- | 1 | -- | -- |
Liftglass Release Actuator Ground | -- | 1 | -- | -- |
1. Liftglass Latch Release Inoperative | ||||
Circuit/System Description
The liftglass release switch is an input to the body control module (BCM). The BCM supplies battery voltage to the signal circuit and when the release switch is activated the signal circuit voltage goes low. The BCM controls the liftglass release actuator through the rear wiper motor control module. When the release switch signal is activated the BCM applies battery voltage as a signal through the liftglass latch release control circuit to the rear wiper motor control module. The rear wiper motor control module supplies voltage to the release actuator through the liftglass release actuator control 2 circuit.
Conditions for Running the DTC
| • | System voltage must be 9-16 volts. |
| • | The liftglass release operation is attempted. |
Conditions for Setting the DTC
The BCM detects a fault in the liftglass release signal circuit.
Action Taken When the DTC Sets
The BCM will disable the liftglass latch release control circuit output until the next ignition cycle.
Conditions for Clearing the DTC
| • | The DTC will be current only while the liftglass release request is active. |
| • | The history DTC will be cleared after 50 fault-free ignition cycles. |
Reference Information
Schematic Reference
Connector End View Reference
Vehicle Access Connector End Views
Electrical Information Reference
Scan Tool Reference
Circuit/System Verification
Ignition ON, command the liftglass latch to release the liftglass by pressing the liftgate window release switch. The liftglass latch should release the liftglass.
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the rear window wiper motor.
- Ignition ON, connect a test lamp between the signal circuit terminal B and ground.
- Command the liftglass latch to release by pressing the liftgate window release switch. The test lamp should briefly illuminate when the liftgate window release switch is pressed.
- If all circuits test normal, replace the rear window wiper motor.
| ⇒ | If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM. |
| ⇒ | If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for BCM replacement, setup, and programming |
