Tools Required

J 1859-A Steering Wheel Puller

1. Disable the supplemental inflatable restraint (SIR) system. Refer to Disabling the SIR System in SIR.
2. Remove the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
3. Remove the horn switch. Refer to Horn Switch Replacement - On Vehicle .
4. Make an alignment mark in order to note the relationship of the steering wheel to the steering shaft.
5. Remove the steering wheel nut.



6. Remove the steering wheel, using the J 1859-A .

1. Align the marks made during the removal procedure on the steering shaft and the steering wheel.



2. Install the steering wheel onto the steering shaft.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the steering wheel nut to the steering shaft.

Tighten
Tighten the nut to 40 N·m (29 lb ft).

4. Install the horn switch. Refer to Horn Switch Replacement - On Vehicle .
5. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
6. Enable the SIR system. Refer to Disabling the SIR System in SIR.