Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

1. Disable the SIR system. Refer to Disabling the SIR System .
2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement in Doors.
3. Loosen the 2 inflatable restraint side impact sensor fasteners (2).
4. Remove the inflatable restraint side impact sensor (1) from the door (4).
5. Remove the connector position assurance (CPA) (3) and disconnect the inflatable restraint side impact sensor yellow 2-way harness connector (5).

1. Connect the inflatable restraint side impact sensor yellow 2-way harness connector (5) to the inflatable restraint side impact sensor (1).
2. Install the connector position assurance (CPA) (3) to the inflatable restraint side impact sensor yellow 2-way connector (5).
3. Install the inflatable restraint side impact sensor (1) to the door (4).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the fasteners (2) to the inflatable restraint side impact sensor (1).

Tighten
Use only hand tools in order to tighten the fasteners to 10 N·m (89 lb in).

5. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement in Doors.
6. Enable the SIR system. Refer to Enabling the SIR System .