GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Tahoe - 2WD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement

Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement Non-HP2

Tools Required

J 39400-A Halogen Leak Detector

Removal Procedure

    Object Number: 1769180 Size: SH
  1. Disconnect the electrical connector from the A/C refrigerant pressure sensor.
  2. Remove the A/C refrigerant pressure sensor (1) from the condenser tube.

Installation Procedure

    Object Number: 1769180 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the A/C refrigerant pressure sensor (1).

    2. Tighten
    Tighten the switch to 6 N·m (53 lb in).

  2. Connect the electrical connector to the A/C refrigerant pressure sensor.
  3. Leak test the fittings of the components using the J 39400-A .
  4. Lower the vehicle.

Air Conditioning (A/C) Refrigerant Pressure Sensor Replacement HP2


Object Number: 1965585 Size: MF

Callout

Component Name

Preliminary Procedures

  1. Disconnect the electrical connector from the pressure sensor.
  2. Remove the upper radiator air baffle.

1

A/C Refrigerant Pressure Sensor

Notice: Refer to Fastener Notice in the Preface section.

Tip
Remove and discard the O-ring. Refer to O-Ring Replacement .

Tighten
6 N·m (53 lb in)