The object alarm detection system senses how close the vehicle is to an object. The distance is determined by the 4 ultrasonic sensors located in the rear bumper. The object detection system will notify the driver when backing up or moving forward while parking at speeds less than 8 km/h (5 mph). The object detection system will use rear display indicators and the radio speakers for notification. The system can be disabled by pressing the ON/OFF button. The ON/OFF indicator will be ON when the system is OFF. The driver information center (DIC) will also display PARK ASSIST OFF.

Ignition voltage is between 9-16 volts.

The object alarm module has detected that the switch circuit is determined to be shorted to ground and must exist for 300 milliseconds.

Schematic Reference

Object Detection Schematics

Connector End View Reference

Object Detection Connector End Views

Description and Operation

Object Detection Description and Operation

Electrical Information Reference

Scan Tool Reference

1. Ignition OFF, disconnect the harness connector at the multifunction accessory switch.
2. Verify the scan tool Park Assist Switch parameter is Inactive.

⇒	If not Inactive, test the rear park assist disable switch signal circuit for a short to ground. If the circuit tests normal replace the object alarm module.

3. If all circuits test normal, replace the multifunction accessory switch.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.