Service Stability Lamp DTC C0710 - keywords ABS brake brakes C0455 C0710 C071000 C07105A code DIC DTC EBCM EBTCM lamp light message stability stabilitrak TCS VSES

This PI was superseded to update model years. Please discard PIT4225.

The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI.

You may experience an ABS lamp followed by a Service Stability message in the Drivers Information Center. After Initial diagnosis, you may have a diagnostic code: C0710 set in the EBCM. Also, DTC C0455 may or may not be set.

If, after normal diagnosis, the vehicle is not repaired. Turn the steering wheel to the straight ahead position and the check the "Steering Wheel Position" parameter using the Tech 2 scan tool. If the steering wheel position is not reading zero (+/- 3 degrees) with the vehicle wheels straight ahead, check the steering wheel and make sure the steering wheel was properly installed. There is an alignment arrow on the steering wheel and a mark on the shaft and they both should be aligned as shown in the picture below.

If the steering wheel is not properly installed, remove the steering wheel and properly align the steering wheel and torque to factory spec per SI. Perform an alignment on the vehicle after the steering wheel has been corrected.

Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.