Tools Required

1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
2. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
3. Remove the rear output shaft seal.



4. Inspect the rear output shaft bushing for scoring or wear.
5. Remove the rear output shaft bushing if required, using the J 45380 .

•	Install the finger section of the J 45380 in front of the bushing.

•	Install the tube and forcing screw to the finger section. Ensure the forcing screw is backed out.

•	Using a wrench on the forcing screw, remove the rear output shaft bushing.

1. Using the J 45380 , install a NEW output shaft bushing.

1.1.	Install the bushing or the finger section of the J 45380 .

1.2.	Install the finger section to the main body of the J 45380 .

1.3.	Position the bushing and tool to the case.

1.4.	Using a hammer and the J 45380 , install the bushing.





Important: Ensure the drain hole on the boot of the rear output shaft seal is facing down toward the ground.

2. Using the J 37668-A , install a NEW front output shaft seal.
3. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
4. Check the fluid level. Add fluid if necessary.
5. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .