GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Tahoe - 2WD 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Front Floor Console Accessory Power Rear Receptacle Cover Replacement

Removal Procedure
  1. Remove the floor console bezel. Refer to Floor Console Bezel Replacement .
  2. Remove the storage bin. Refer to Front Floor Console Compartment Replacement .
  3. Remove the floor console end panel. Refer to Center Console End Panel Replacement .

    4. Important: Do not disconnect the electrical connectors.

  4. Separate the end panel from the console in order to gain access to the retaining screws.

    5. Object Number: 752595 Size: SH
  5. Remove the 2 screws (1) retaining the power outlet cover to the console end panel.
  6. Remove the cover from the end panel.

Installation Procedure

    Object Number: 752595 Size: SH
  1. Install the power outlet cover to the end panel.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the 2 retaining screws (1).

    3. Tighten
    Tighten the screws to 1.6 N·m (14 lb in).

  3. Install the console end panel. Refer to Center Console End Panel Replacement .
  4. Install the storage bin. Refer to Front Floor Console Compartment Replacement .
  5. Install the console bezel. Refer to Floor Console Bezel Replacement .