GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Tahoe - 2WD 🢒 Body and Accessories 🢒 Instrument Panel, Gauges, and Console 🢒 Engine Oil Level Sensor Replacement

Removal Procedure

    Object Number: 178467 Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the oil pan drain plug.
  3. Completely drain the engine oil.
  4. Disconnect the engine oil level sensor electrical connector.
  5. Remove the engine oil level sensor.

Installation Procedure

    Object Number: 178467 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the drain plug to the oil pan.

    2. Tighten
    Tighten the drain plug to 25 N·m (18 lb ft).

  2. Install the engine oil level sensor.

    3. Tighten
    Tighten the engine oil level sensor to 13 N·m (115 lb in).

  3. Connect the electrical connector to the engine oil sensor.
  4. Lower the vehicle.
  5. Refill the engine with the recommended oil.