GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Spark 🢒 Brakes 🢒 Antilock Brake System 🢒 Brake Pressure Modulator Valve Assembly Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1618008 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disconnect the electronic brake control module (EBCM) connector (1).

    3. Object Number: 1618009 Size: SH
  3. Remove the brake pipes from the brake pressure modulator valve (BMPV) assembly.
  4. Plug the brake pipes.
  5. Loosen the mounting nuts (2) on the BPMV assembly (1).
  6. Position the brake pipes aside far enough to allow for lifting the BPMV assembly from the mounting bracket.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1618009 Size: SH
  1. Install the BPMV assembly (1) into the mounting bracket. Secure with 2 nuts (2).

    2. Tighten
    Tighten the nuts to 15 N·m (11 lb ft).

  2. Remove the plugs from the brake pipes and connect the brake pipes to the BPMV assembly (1).

    3. Tighten
    Tighten the brake pipe nuts to 22 N·m (16 lb ft).


    Object Number: 1618008 Size: SH
  3. Connect the electronic brake control module (EBCM) connector (1).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Bleed the brake system. Refer to Hydraulic Brake System Bleeding .
  6. Perform the Diagnostic System Check - Vehicle .
  7. Refer to Control Module References for programming and setup information.