GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Spark 🢒 Engine 🢒 Engine Controls - 0.8L 🢒 Fuel Injection Fuel Rail Assembly Replacement

Removal Procedure

    Notice: Refer to Fuel Pressure Notice in the Preface section.


    Object Number: 1225022 Size: SH
  1. Relieve the fuel system pressure. Refer to Fuel Pump Replacement .
  2. Remove the canister from the engine compartment. Refer to Evaporative Emission Canister Replacement .
  3. Disconnect the fuel inlet line (1).

    4. Object Number: 1225025 Size: SH
  4. Disconnect the fuel injector harness connectors (1).

    5. Object Number: 1224970 Size: SH
  5. Remove the fuel rail bolts (1).

    6. Notice: 

       • Use care when servicing the fuel system components, especially the fuel injector electrical connectors, the fuel injector tips, and the injector O-rings. Plug the inlet and the outlet ports of the fuel rail in order to prevent contamination.
       • Do not use compressed air to clean the fuel rail assembly as this may damage the fuel rail components.
       • Do not immerse the fuel rail assembly in a solvent bath in order to prevent damage to the fuel rail assembly.

  6. Remove the fuel rail with the fuel injectors attached (2).

    7. Object Number: 1225059 Size: SH

    Important: Different fuel injectors are calibrated for different flow rates. When ordering new fuel injectors, be certain to order the identical part number that is inscribed on the old fuel injector.

  7. Remove the fuel injector retainer clips (1).
  8. Remove the fuel injectors by pulling them down and out (2).
  9. Discard the fuel injector O-rings (3).

Installation Procedure

    Caution: Refer to Safety Goggles and Fuel Caution in the Preface section.


    Object Number: 1225018 Size: SH

    Important: If a fuel injector becomes separated from the fuel rail and remains in the cylinder head, replace the fuel injector O-ring seals and the retaining clip.

  1. Lubricate the new fuel injector O-rings with engine oil. Install the new O-rings on the fuel injectors.
  2. Install the fuel injectors.
  3. Install the fuel injector retaining clips (1).

    4. Object Number: 1224970 Size: SH
  4. Install fuel rail with fuel injectors attached (2).

    5. Notice: Refer to Fastener Notice in the Preface section.

  5. Install fuel rail retaining bolts (1).

    6. Tighten
    Tighten the fuel rail retaining bolts to 18-22 N·m (13-16 lb ft).


    Object Number: 1225025 Size: SH
  6. Connect the fuel injector harness connector.

    7. Object Number: 1225022 Size: SH
  7. Connect the fuel inlet line (1).
  8. Install the EVAP canister. Refer to Evaporative Emission Canister Replacement .
  9. Turn the ignition ON and inspect the fuel system for leaks.