1

Roof Panel Joint Finish Molding (Rear)

Notice: Refer to Exterior Trim Emblem Removal Notice in the Preface section.

Tip

1. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
2. Remove the roof panel finish joint from the roof ditch.
3. Use of a heat gun is recommended.
4. Using a 50/50 mixture of isopropyl alcohol and clean drinkable water and a clean towel, remove the left over adhesive residue from the ditch.
5. Wipe the roof ditch clean with a clean dry towel.
6. Peel the adhesive tape backing from the roof panel joint finish molding.
7. Secure the molding starting at the front edge working rearward.
8. Completely wet out the roof panel finish joint molding.