GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The body control module (BCM) supplies battery positive voltage to the reading lamps, instrument panel (I/P) compartment lamp, and both visor vanity mirror lamps. In the event that any of these lamps were to remain illuminated for more than 20 minutes with the ignition switch in the OFF position, the BCM will deactivate the inadvertent supply voltage circuit to prevent a total battery discharge condition.

Conditions for Running the DTC

The battery voltage must be between 9.0-16.0 volts.

Conditions for Setting the DTC

    • The inadvertent power supply voltage circuit to the reading lamps, I/P compartment lamp, and both visor vanity mirror lamps is shorted to ground for more than 1 second.
    • There is a loss of the rear fuse block TBC 4 battery supply voltage to the BCM for more than 1 second while one or more of the lamps in the inadvertent power supply voltage circuit have been activated.

Action Taken When the DTC Sets

The reading lamps, I/P compartment lamp, and both visor vanity mirror lamps will not operate.

Conditions for Clearing the MIL/DTC

    • This DTC will clear on current status after the condition for setting the fault is corrected.
    • A history DTC will clear after 100 consecutive ignition cycles without a fault present.
    • History and current DTCs can be cleared using a scan tool.

Diagnostic Aids

Perform a visual inspection for loose or poor connections at all related components. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. This step test determines if an open or short to ground exists.

  2. This step test determines if a short to ground exists in the lamp wiring or internally within the BCM.

  3. This step test determines if an open exists in the TBC 4 battery positive voltage circuit, the inadvertent power supply voltage circuit, or internally within the BCM.

  4. After replacement of the BCM you must calibrate the new module for proper operation.

Step

Action

Yes

No

Schematic Reference: Interior Lights Schematics

Connector End View Reference: Lighting Systems Connector End Views or Body Control System Connector End Views in Body Control System

1

Did you perform the Lighting System Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

2

Inspect the TBC 4 fuse in the rear fuse block.

Is the fuse good?

Go to Step 4

Go to Step 3

3

Test the TBC 4 battery positive voltage and inadvertent power supply voltage circuits for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 5

4

Test the TBC 4 battery positive voltage and inadvertent power supply voltage circuits for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 5

5

Inspect for poor connections at the harness connectors of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 7

Go to Step 6

6

Important: Perform the setup procedure for the BCM.

Replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 7

--

7

  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK