The data link connector (DLC) allows a scan tool to communicate with modules on the class 2 serial data line. The serial data line is the means by which the microprocessor-controlled modules in the vehicle communicate with each other. Once the scan tool is connected to the class 2 serial data line through the DLC, the scan tool can be used to monitor each module for diagnostic purposes and to check for diagnostic trouble codes (DTCs). Class 2 serial data is transmitted on a single wire at an average of 10.4 kbps. This value is an average, class 2 uses a variable pulse width modulation to carry data and depending on the message it may operate faster or slower. The bus will float at a nominal 7.0 volts during normal operation. Each module can pull this lower during the transmission. The bus is not at battery positive voltage or ground potential during normal operation. When the ignition switch is in RUN, each module communicating on the class 2 serial data line sends a state of health (SOH) message every 2 seconds to ensure that the module is operating properly. When a module stops communicating on the class 2 serial data line, for example if the module loses power or ground, the SOH message it normally sends on the data line every 2 seconds disappears. Other modules on the class 2 serial data line, which expect to receive that SOH message, detect its absence; those modules in turn set an internal DTC associated with the loss of SOH of the non-communicating module. The DTC is unique to the module which is not communicating, for example, when the inflatable restraint sensing and diagnostic module (SDM) SOH message disappears, several modules set DTC U1088. Note that a loss of serial data DTC does not normally represent a failure of the module that set it.

On some vehicles, if the PCM is unable to communicate with the VTD system after the vehicle has started, the PCM will consider the VTD system to be malfunctioning. The PCM will enter a fail enable state and will command the security indicator to illuminate. When the PCM is in a fail enable state the vehicle will NOT stall or stop running. If the PCM is in a fail enable state when the ignition is switched OFF, the PCM will remain fail enable until communications with the VTD system has been restored. When the PCM is in a fail enable state the VTD system is NOT active and the vehicle will start. This feature is NOT available on all GM vehicle lines.

The class 2 serial data line on this vehicle is a ring/star configuration. The following modules communicate on the class 2 serial data line:

The data link connector (DLC) allows a scan tool to communicate with the class 2 modules. The DLC is a standardized 16 cavity connector located below the instrument panel and close to the steering column. Connector design and location is dictated by an industry wide standard, and it is required to provide the following:

Refer to Data Link Communications Connector End Views .

Each control module connected to the class 2 serial data circuit monitors serial data communications during normal vehicle operation. Operating information and commands are exchanged among the modules. In addition, node alive messages are transmitted by each module on the class 2 serial data circuit about once every 2 seconds. If a module does not receive a node alive message when expected, a DTC will set. If a module detects that the class 2 serial data circuit is shorted, the setting of all other class 2 serial communication DTCs is inhibited, and DTC U1300, U1301, or U1305 will set.

The transfer case shift control module is equipped with the ability to store diagnostic information, which is useful to a technician in the event of module, component or wiring concerns. This information can be retrieved via the diagnostic enable circuit from the transfer case shift control module by way of flash codes, which are displayed on the three transfer case shift control switch buttons. These buttons are located on the instrument panel to the right of the steering wheel. For diagnosis of this circuit, refer to Diagnostic Starting Point - Transfer Case in Transfer Case-NVG 233-NP1.