GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 S10 Pickup - 4WD 🢒 Body and Accessories 🢒 Seats 🢒 Bucket Seat Replacement

Removal Procedure
  1. Remove the seat adjuster trim covers. Refer to Front Seat Adjuster Track Finish Cover Replacement .

    2. Object Number: 298921 Size: SH
  2. Remove 3 seat mounting nuts.
  3. Remove the seat mounting bolt.
  4. Disconnect the electrical connectors from seat if necessary.
  5. Remove the seat from the vehicle.

Installation Procedure
  1. Position the seat on the 3 seat mounting studs on the floor of the vehicle.

    2. Object Number: 298921 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the seat mounting bolt.

    3. Tighten
    Tighten the seat mounting bolt to 70 N·m (52 lb ft).

    Install the seat mounting nuts.

    Tighten
    Tighten the seat mounting nuts to 45 N·m (33 lb ft).

  3. Install the seat adjuster trim covers. Refer to Front Seat Adjuster Track Finish Cover Replacement .