Important: This procedure calls for the replacement of incandescent bulbs only. The light emitting diodes (LED's) are not replaceable individually. If LED replacement is needed, replace the entire instrument panel cluster (IPC). Refer to Instrument Cluster Replacement .

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Remove the instrument panel (IP) cluster. Refer to Instrument Cluster Replacement .



3. Unclip the IP cluster rear cover plate by prying gently on the tabs with a screwdriver.



4. Remove the rear cover plate from the IP cluster.



5. Remove the bulb and base assembly by turning the bulb one-half turn counter clockwise and pulling outward. Refer to Bulb Usage in Lighting Systems.

Important: This procedure calls for the replacement of incandescent bulbs only. The light emitting diodes (LED's) are not replaceable individually. If LED replacement is needed, replace the entire instrument panel cluster (IPC). Refer to Instrument Cluster Replacement .

1. Install the bulb(s) into the cluster by inserting the bulb and base assembly and turning the bulb one-half turn clockwise.



2. Carefully snap the rear cover plate to the IP cluster.
3. Install the IP cluster. Refer to Instrument Cluster Replacement .
4. Connect the negative battery cable.