GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Tools Required

J 43013 Multec 2 Fuel Injector Assembly Removal Tool


    Object Number: 12687  Size: SH

    Caution: Relieve the fuel system pressure before servicing fuel system components in order to reduce the risk of fire and personal injury.

    After relieving the system pressure, a small amount of fuel may be released when servicing the fuel lines or connections. In order to reduce the chance of personal injury, cover the regulator and the fuel line fittings with a shop towel before disconnecting. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.

  1. Relieve fuel system pressure. Refer to Fuel Pressure Relief .
  2. Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  3. Disconnect the negative battery cable.
  4. Remove the fuel rail. Refer to Fuel Injection Fuel Rail Assembly Replacement .
  5. Remove the fuel injector retaining clip (2).
  6. Remove the fuel injector (3) using the J 43013 .

Installation Procedure


    Object Number: 12687  Size: SH

    Important:  Each fuel injector is calibrated for a specific flow rate. When replacing fuel injectors, be sure to order the correct fuel injector for the application being serviced.

  1. Lubricate new fuel injector O-ring seals (1)(4) and (5) with clean engine oil, and install on the fuel injector assembly (3).
  2. Important: When installing the fuel injector, care should be taken not to tear or misalign the fuel injector O-rings.

  3. Install the fuel injector upper O-ring (1).
  4. Install the fuel injector lower back-up O-ring (4).
  5. Install the fuel injector lower O-ring (5)
  6. Install the fuel injector (3) to the fuel rail.
  7. Install the fuel injector retaining clip (2).
  8. Install the fuel rail. Refer to Fuel Injection Fuel Rail Assembly Replacement .
  9. Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  10. Connect the negative battery cable.
  11. Inspect for leaks through the following steps:
  12. 9.1. Turn the ignition switch ON for 2 seconds.
    9.2. Turn the ignition switch OFF for 10 seconds.
    9.3. Turn the ignition switch ON.
    9.4. Check for fuel leaks.