Service Precautions
| • | Avoid washing vehicles in direct sunlight. |
| • | Avoid using strong soaps or chemical detergents. |
| • | Use brushless type automatic car wash equipment. |
| • | Avoid using products containing acids, unless specified in order to correct a condition such as rail dust. |
| • | Do not use brushes or brooms in order to remove snow or ice from vehicles in storage or on lots. |
| • | Cleaning agents and water should be dried promptly and not allowed to dry on the surface. |
| | Drying with a soft chamois is recommended. |
| • | Standing rinse water should be dried promptly and not allowed to dry on the surface. |
| | Drying with a soft chamois is recommended. |
| • | If a surface condition does exist, the repair approach should be one of less is best, the very least it takes to correct the condition. |
| • | Avoid removing too much clear coat whenever possible, use paint gages before, during and after polishing. Refer to
Paint Gages
. |
| • | Do not use wax or silicone type products in order to hide swirl marks, this damage will reappear later and cause customer dissatisfaction. |
| • | Specific conditions on the paint (environmental damage, rail dust, etc.) may be corrected by: |
Repair Procedure
Notice: Removing more than 0.5 mils of the clearcoat can
result in early paint failure. The clearcoat contains ultraviolet screeners.
Do not finesse sand more than what is required to remove the defect.
- Thoroughly wash the repair area with Liquid Wash and Wax GM P/N 1052870 or the equivalent.
- Readings of the paint film build should be taken prior to the operation. Refer to
Paint Gages
.
- Apply a small amount of the appropriate material to repair area and smear evenly with the pad. Refer to
Clearcoat Repair Specifications - Meguiar Products
or
Clearcoat Repair Specifications - 3M Products
.
- With the polisher running at approximately 1,500-2,000 RPM, polish the repair area. Keep the pad flat against the panel while applying heavier pressure for 4-6 seconds. Then, polish with lighter pressure for 6-8 seconds.
Feature lines and panel edges should be hand-rubbed in order to avoid burn-through.
- Inspect the repair area frequently. Add more of the appropriate material as needed.
- Always blend or feather the outer edges of the repaired area.
- After buffing, inspect the repaired area.
- If swirls are still visible, repeat the buffing procedure.
- Clean the repaired area using a clean soft, non-scratching cloth with a 50/50 mixture of Isopropyl Alcohol and water.
- If sanding is required, refer to
Clearcoat Repair Specifications - Meguiar Products
or
Clearcoat Repair Specifications - 3M Products
.
